DWC Owners Forum

Vectric Aspire => Vectric Aspire 2.5D / 3D => Topic started by: fwharris on July 05, 2016, 07:00:54 PM

Title: Help needed in setting up a raster carve
Post by: fwharris on July 05, 2016, 07:00:54 PM
I have done a boat load of vector and pocket cuts and very few raster type carves. The raster carves I have done were very small sized but still took way longer than expected. Most likely do to the settings I used in setting up the carve.

Now I have a large project in want to do. It is a grizzly bear breaking through a door. See image... This will be done for an actual door for a good friend.

What I need is some guidance for best settings to use.

I am using Aspire for the design and tool path set up and cnc usb controller software at the machine.
Title: Re: Help needed in setting up a raster carve
Post by: fwharris on July 07, 2016, 07:53:47 PM
I guess no one has any clue either.. HMMMM
Title: Re: Help needed in setting up a raster carve
Post by: fwharris on July 16, 2016, 10:03:41 PM
Just a shout out to Laney for the great help he gave to me today. Things became clearer a lot more after spending some time with him.

Thanks!