DWC Owners Forum


Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - James Bu

Pages: [1]

I ordered this slat wall from Mills Distibruting.  It appears to be a dense / higher quality slatwall.  I am please with the quality and I have spent a full day tuning the machine. The chart below illustrates the final "Z" axis elevations at various locations:

Has anyone been able to achieve tighter tolerances?  If so, how?

General Discussion / Re: Forum settings
« on: July 22, 2017, 08:27:50 AM »
This may be why many of the attachments are not found.

General Discussion / Forum settings
« on: July 22, 2017, 08:27:16 AM »
The attachments upload directory is not writable. Your attachment or avatar cannot be saved.

G-Code Trading Post / Re: First Attempt at Drag Engraving
« on: July 22, 2017, 08:22:45 AM »
What bit are you using?

Vector Graphic Trading Post / Re: DXF to share
« on: July 22, 2017, 08:12:30 AM »
404 attachment not found.

Pages: [1]