DWC Owners Forum

Guest


Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Josh D

Pages: [1]
1
General Discussion / Help Please
« on: December 22, 2015, 11:09:33 AM »
I am trying to get my DWC up and running. I have the PC connected to the controller and everything seems ok, but when I import a gcode file from vectric vcarve to USBCNC and hit play the router instantly goes all the way up on its z and tries to force past its limit. It then starts cutting around 3 inches above the worksurface. I assume it is because it is thrown off axis when it limits out on the z axis. Any ideas why it might be doing this?

Pages: [1]