DWC Owners Forum


Author Topic: Adding tabs in bbcad  (Read 1029 times)


  • Guest
Adding tabs in bbcad
« on: October 23, 2011, 09:44:33 PM »
I'm cutting a profile to full thicknes of the stock. I would like to add tabs (maybe 3) to hold the work piece
inplace will the profile is cutting. I do not have BobNest to help, maybe you have a solution.
Please play in forward.

Thank You


  • Administrator
  • Full Member
  • *****
  • Posts: 181
  • Woodworking - patience = firewood
    • View Profile
Re: Adding tabs in bbcad
« Reply #1 on: October 24, 2011, 04:53:38 AM »
The way I would suggest is to cut small segments out of your outline. You may want to create a offset line so it doesn't mess up your original outline.
To cut those small segments, just simple create two line that cross where you want the missing area than trim to those lines.

This Youtube video shows how to trim and break.
Hope that helps

Burl :)