Hello everyone
With the summer being a little slow with sales, I've done a few things with the DWC.
I'm making 25 of these signs for a friends daughter. You can make some good money by doing these interesting items.
This was ran in three steps.
1. Inside pockets- the reason for pocketing is so you don't have little pieces breaking the letters when they come lose.
2. Outside profile- before you can run this you have to screw down a 1/4" plywood to hold the piece in place once it breaks free.
3. Vcarve the letters
Couple of side notes, I did cuts inside the "S" so there were no pieces breaking lose. Also don't forget to make your rapid travel above your 1/4" plywood or you can cut into the screws that are holding it down. Yes, that happen to me.
Let me know if you would like the G-code to play with.

Burl