DWC Owners Forum


Author Topic: how to stop machine and restart  (Read 931 times)

Harold Sh

  • Newbie
  • *
  • Posts: 6
    • View Profile
how to stop machine and restart
« on: November 19, 2015, 06:25:28 AM »
made a design in v-carve pro and did not realize it was 17 hours in the making. long story short I stopped it after 6 hours and hoping it would start back up at the same location. Wrong how to do this?? thanks Harold
Shenhui 350 laser 50w
Full Spectrum laser 40w
DWC and lots of woodworking tools
Corel draw 5


  • Administrator
  • Full Member
  • *****
  • Posts: 181
  • Woodworking - patience = firewood
    • View Profile
Re: how to stop machine and restart
« Reply #1 on: November 20, 2015, 05:36:43 AM »
One of the things you have to watch is the step over. Normally .015-.020 is what I use. If you made it .001 than the program would take 15 times longer.


Yes you can start where you left off. Right click on the g-code box and click on "Start from Line". Just make sure you it is gray on the line you want to start on and the spindle is running.