DWC Owners Forum

Guest


Author Topic: Help needed in setting up a raster carve  (Read 375 times)

fwharris

  • Newbie
  • *
  • Posts: 12
    • View Profile
    • RingNeckBlues
Help needed in setting up a raster carve
« on: July 05, 2016, 07:00:54 PM »
I have done a boat load of vector and pocket cuts and very few raster type carves. The raster carves I have done were very small sized but still took way longer than expected. Most likely do to the settings I used in setting up the carve.

Now I have a large project in want to do. It is a grizzly bear breaking through a door. See image... This will be done for an actual door for a good friend.

What I need is some guidance for best settings to use.

I am using Aspire for the design and tool path set up and cnc usb controller software at the machine.
« Last Edit: July 06, 2016, 08:12:06 AM by fwharris »

fwharris

  • Newbie
  • *
  • Posts: 12
    • View Profile
    • RingNeckBlues
Re: Help needed in setting up a raster carve
« Reply #1 on: July 07, 2016, 07:53:47 PM »
I guess no one has any clue either.. HMMMM

fwharris

  • Newbie
  • *
  • Posts: 12
    • View Profile
    • RingNeckBlues
Re: Help needed in setting up a raster carve
« Reply #2 on: July 16, 2016, 10:03:41 PM »
Just a shout out to Laney for the great help he gave to me today. Things became clearer a lot more after spending some time with him.

Thanks!